Skip to content
PPF WERK

Protective film outdoors: garden tables and outdoor areas

In short

We do not approve the protective film for outdoor use: there is no documented value for it, for example on sun or weather. It is intended for surfaces indoors. If you still want to try it, a test area with the sample set helps.

Garden table, balcony, terrace: why we do not recommend the film outdoors, what is missing and what alternatives there are for indoors.

Updated:

Close-up of a walnut dining table, a subtle film edge at the table corner, chairs in front of a window behind.

An honest answer

The question comes up often, especially in summer: can I protect my garden table or balcony furniture with the film? Our honest answer is: we do not approve the film for that.

The reason is simple. We cannot document what would happen outdoors. There is no data-sheet value for sun, wet or changing temperatures, and as long as there is none, we say nothing positive about it. Better a clear no than a promise we cannot keep.

That also applies if the surface stands sheltered under a canopy or is only used in summer. The question is not how weatherproof your spot is, but whether we can document the film for it.

Intended for indoors

The film is developed and described for surfaces indoors: dining table, desk, kitchen fronts, worktops, furniture, doors, windowsills. All notes on our pages, from surface suitability to care, relate to this use.

For the windowsill too: we have no value for resistance in direct sun. We therefore do not advertise it.

Living & interior

What about covered areas?

For covered terraces, conservatories or balconies too, we cannot give a blanket approval. Anyone who wants to try anyway bears the risk themselves and should set up a small, inconspicuous test area and observe it over a longer period.

The sample set contains a piece of each film. With it you can check adhesion and look on your surface. For unclear substrates we also check adhesion on a sample of your material.

View the sample set

What you can do instead

A tabletop that normally stays in the living room but is occasionally carried outside in summer is a borderline case. Everyday life indoors is documented, time outdoors is not. Decide for yourself whether you take that risk.

For garden furniture itself there are covers, tablecloths and care products made for outdoors. We cannot say anything about them, because we do not carry or test these products.

For everything indoors you are in the right place with us. If you have a table that stands indoors but is occasionally carried onto the terrace, the film protects the panel in everyday use. We do not recommend leaving it outside permanently, though.

Table protection film made to measure

What we can say with certainty for indoors

For indoors a lot is established: which surfaces are suitable, how the film is applied wet and squeegeed, how long it cures and how you care for it. All of that is in the guide, and we can back it up.

The limits are clearly stated too: the film is not heat protection, does not replace a chopping board and does not suit oiled or waxed woods. Anyone who sticks to that has a solution indoors that works reliably in everyday use.

So if you want to protect a dining table, a desk or a kitchen, the film is a good choice. Start with the assistant or the configurator and fix the dimensions.

Installation and care

When this can change

As soon as we have a documented data-sheet value on sun and weather, we will write it here and on the product pages. Until then we leave the statement out instead of guessing.

Until then a simple rule applies for us: what we cannot document, we do not promise. That applies equally to sun, rain, frost and heat outdoors, and it applies to every film in the range, not just one.

If you have a specific surface in mind, send us a photo and a short description. We will tell you openly what we know about it and what we do not.

Ask a question

Frequently asked questions

May I use the film on the balcony?

We do not approve the film for outdoor use because there is no documented value for it. It is intended for surfaces indoors.

Does the film hold up in the sun?

We make no statement on that, as we have no data-sheet value for resistance in direct sun. That also applies to the windowsill.

Can I still try it?

At your own risk: set up a small test area and observe it. The sample set helps to check adhesion and look.

Will the statement change?

Yes, as soon as we have a documented value. Until then we say nothing we cannot back up.